28
FOLDING & UNFOLDING
ASSEMBLY
Place one foot on the platform. Lift the folding handle safety upwards, then with your left
hand push the mast forward and with your right hand pull the folding handle towards you to
fold the mast back onto the platform.
Ref : FX11
1
2
Place one foot on the platform. With your left hand push the mast forward and with your
right hand pull the folding handle towards you to fold the mast back onto the platform.
You can fold up the handles of your scooter by pushing the blue bushings outward.
Warning
• Folding and unfolding Beeper electric scooters can be difficult for the first few times.
• Before folding your scooter, make sure that it is switched off.
Ref : FX11
Ref : FX8 • FX10
1 2
5 6
3 4
Unscrew the screw
located on the top of
the mast
Remove the screw
and the cap
Insert the handlebars in its location and slightly
tighten the screws on each side of the mast
Screw the cover and
its screw on the top of
the mast again
Retighten the various
screws on each side of
the handlebars
If you have difficulty folding your electric scooter, you can loosen the screw on the front of
the folding mechanism (red arrow opposite). This screw is used to inflate or deflate by
compression a tube. The more the tube is compressed the more difficult the folding will be,
however be careful not to decompress the tube too much, it also helps to avoid play in the
folding mechanism when using the scooter.
To Next Page
Loading...
Need help?
General
