18
86076 DB-en/03 355.00032
English
⋅
LaserStar T Plus
Alphanumeric input window
The touchscreen shows a window with an alphanu-
meric keyboard if any numeric value for parameters
or names for storage spaces or pulse shapes are to
be entered (see following example).
Fig. 8 Alphanumeric input window
General Functions
The following functions are basically available in this
input window.
• Cursor position
If a text or a number is indicated, immediately
after having opened the input window the (invi-
sible) cursor is positioned at the end of the input
line (in the example right of numeral 9).
Prior to enter a new text delete the indicated
text step by step with the [
] button.
•Button [
]
Use this button to switch the indicated keyboard
for the input of capitals. Touching the button
again (in capital mode) switches back to the
input of lower case characters.
•Button [
]
This button closes the input window. the
entered values or texts are taken to the higher-
level window.
Service menus
The service menus are divided into four levels with
different access rights.
General instructions concerning the ser-
vice menus
The following buttons are generally available in the
service menus.
User: Each user without restriction,
no password is necessary
Engineer: Technically knowledgeable user,
generally the supervisor of the
customer
The password (factory setting "e" -
heed the case sensitivity) can be
changed by the engineer.
Service: Service personnel trained and autho-
rized by BEGO,
Password-protected
Setup: Only employees of BEGO,
Password-protected
[ Back ] /
[ Forward ]
This buttons switch you to the
next or prior menu page.
[ User ] /
[ Engineer ]
[ Service ] /
[ Setup ]
These buttons open the menus
for the corresponding service
level (having entered the correct
password).
[ Close ] Close the service menu with this
button.
Any settings that have been
made are accepted.
To Next Page
Loading...