Need help?Do you have a question about the Bego LaserStar T Plus and is the answer not in the manual?
General| Laser Type | Diode laser |
|---|---|
| Wavelength | 810 nm |
| Cooling System | Air cooling |
| Power Supply | 100 - 240 V, 50/60 Hz |
| Operation Modes | pulsed |
| Display | Touchscreen |
Covers safe design, intended use, and prohibited usage of the laser device.
Identifies hazardous zones, emergency stops, safety switches, and protective measures.
Addresses personnel qualifications, laser beam hazards, eye protection, and fire risks.
Details protective equipment and employer/personnel obligations for safe operation.
Details risks from gases, noise, water handling, and immediate actions for burns.
Provides general instructions for servicing and maintenance tasks.
Describes the EMERGENCY STOP, main switch, and key switch controls.
Details touch screen functions, chamber controls, and footswitch operation.
General operating instructions and considerations for the workplace setup.
Step-by-step procedure for powering on the laser device.
Procedures for testing the laser protective window and safety switches.
Explains pulse shape influence and how to access the editor.
Guides on selecting, editing, and naming laser pulse shapes.
Provides fundamental guidance for dental welding applications, covering joint planning.
Details using welding wire and considerations for different alloy compositions.
Explains how status/error messages are displayed and categorized.
Details handling of error messages and interlock system responses.
Tables providing recommended welding parameter settings and pre-set values.
To Next Page
