25
86076 DB-en/03 355.00032
English
⋅
LaserStar T Plus
Installation
Unpacking
The laser device has been tested thoroughly before
shipping and has been delivered in faultless
condition. Check the packaging for transport
damages - if possible - before unpacking.
1. Take the device - if possible unpacked - to the
final installation site.
2. Leave the device in its packaging long enough
to allow it to acclimatize to its new environment
and prevent the formation of condensation.
3. Carefully remove the packaging if any.
4. Check the delivered parts for possible damage
during transport.
5. Check to see if the delivery is complete.
Basic Equipment
The standard parts of delivery are listed in the
following:
• Complete welding Laserstar T Plus
• Two keys for the key switch
• Microscope
• Retaining ring for the microscope
• 3 m protective gas hose
• Digital pedal switch, double-stage
• 2 Power supply cable (EU and USA/Japan)
• Fill tube with funnel
• Adjusting aid
• Adapter connection Argon
• Adapter for Ventus
• 10 liters of deionised water
• Documentation, consisting of:
• Instruction manual
• EU declaration of conformity
• Parameter table
High weight!
At least two people are needed to
carry the device.
Make sure that the table has a load
bearing capacity of > 60 kg when
setting up the LaserStar T Plus.
To Next Page
Loading...