BEGODE Extreme - Charging the Unicycle; Maintenance and Care

Before charging, turn off the unicycle. Plug the charger first into the wall and then
connect it to the unicycles charging port
Charging from 0%-100% takes about 4.5 hours the standard charger and about
half that with two chargers.
It is recommended to charge your unicycle at room temperature.
WARNING!
DO NOT charge the scooter if the charge port or power cord is wet.
DO NOT charge or use your baery if it is damaged or see trace of water.
Aer charging always place the charging port cover back over the charging port.
7 (ENG) 8
4. Charging
5. Serial Number
Begode electric unicycles have a unique serial number. You
are going to need this number when there is any problem or
queson you may have about your unicycle.
The serial number can be found on the rim of the unicycles
motor or seen in the app.
Keep the serial number saved for future reference. You will
also need the serial number in case you intend to have your
scooter insured.
!
6. Maintenance
Regularly check the condion of the re and add pressure if necessary. The recommended pressure is
between 1.5 and 3.2 bar, but it can be lower depending on the weight of the rider, driving style and re
type. NOTE: Riding with lower pressure can cause a puncture or damage to the rim. DO NOT ride an
electric unicycle if the re is damaged or does not hold air.
Ensure that the unicycles shell and other components remain ghtly together, especially aer falls or
impacts, and that there are no cracks in the casing or between parts of the casing where dust and
moisture can damage the wheel. If they occur, the wheel should be serviced immediately and repaired if
necessary.
Compared to an electric scooter, an electric unicycle is (with careful use) much more maintenance-free,
as there are no components that can become loose, such as the handlebars, the folding mechanism and
the brakes. Nonetheless, there are also sensive areas on the unicycle that require regular inspecon
and maintenance.
The maintenance intervals required for the warranty to be valid are: 1) 300km since purchase. 2) Every
1000km or at least once a year - regular maintenance. The maintenance is carried out by the official
maintenance partner Voltride Service (voltride.com).
Cleaning - Use a damp so cloth to clean the electric unicycle. Use a brush to clean dirt that is difficult
to remove. DO NOT use alcohol or any other solvents to clean the electric single wheel. DO NOT use a
pressure washer or water to clean the electric unicycle. Also, do not immerse the electric unicycle in
water. The electric unicycle is not waterproof. Water damage will void the warranty.
Storage - Switch off the electric unicycle and disconnect the charger for storage. Ensure that the baery
is approximately 50-60% charged. Check the baery charge level at least once every two months. If it
has dropped, recharge the baery unl it is about 50-60% charged. Store the electric unicycle in a dry
room at a temperature of about 15-25°C.
WARNING! As with any mechanical component, the electric unicycle is subject to stress and wear
during use. Different materials and components age and wear differently. If the expected service life of a
component is exceeded, it may break unexpectedly, causing injury to the user. Cracks, scratches and
discolouraon indicate that a part under high stress has exceeded its service life and should be replaced.
Such latent defects are checked during regular maintenance. At the same me, the user must also watch
for such defects and service the wheel if necessary.
!
Charging ports are under the
trolley handle
1
2
3
4
5
6
7
8
9