Behringer 173 QUAD GATE/MULTIPLES - User Manual

Quick Start Guide
173 QUAD GATE/MULTIPLES
Legendary Analog Quad Gate &
Multiples Module for Eurorack
Controls
(1) GATE OUT – Send the gate signal to another module via
3.5 mm TS cable.
(2) GATE IN – Connect an incoming signal via
3.5 mm TS cable.
(3) GATE CV – Connect a control voltage signal from other
modules to control gate operation, non-inverting
(active high) and inverting (active low) inputs.
(4) MULTIPLES – Connect a signal to the A jack that will be
sent to multiple designations via the B, C and D jacks in
the same row.
Power Connection
The module comes with the required power cable for connecting
to a standard Eurorack power supply system. Follow these
steps to connect power to the module. It is easier to make
these connections before the module has been mounted into
a rack case.
1. Turn the power supply or rack case power o and
disconnect the power cable.
2. Insert the 16-pin connector on the power cable into the
socket on the power supply or rack case. The connector has
a tab that will align with the gap in the socket, so it cannot
be inserted incorrectly. If the power supply does not have
a keyed socket, be sure to orient pin 1 (-12 V) with the red
stripe on the cable.
3. Insert the 10-pin connector into the socket on the back of
the module. The connector has a tab that will align with the
socket for correct orientation.
4. After both ends of the power cable have been securely
attached, you may mount the module in a case and turn on
the power supply.
Installation
The necessary screws are included with the module for mounting
in a Eurorack case. Connect the power cable before mounting.
Depending on the rack case, there may be a series of xed holes
spaced 2 HP apart along the length of the case, or a track that
allows individual threaded plates to slide along the length
of the case. The free-moving threaded plates allow precise
positioning of the module, but each plate should be positioned in
the approximate relation to the mounting holes in your module
before attaching the screws.
Hold the module against the Eurorack rails so that each of the
mounting holes are aligned with a threaded rail or threaded
plate. Attach the screws part way to start, which will allow
small adjustments to the positioning while you get them all
aligned. After the nal position has been established, tighten the
screws down.
(1)
(2)
(3)
(4)

Summary

Controls

GATE OUT

Send the gate signal to another module via 3.5 mm TS cable.

GATE IN

Connect an incoming signal via 3.5 mm TS cable.

GATE CV

Connect a control voltage signal from other modules to control gate operation.

MULTIPLES

Connect a signal to the A jack that will be sent to multiple designations via B, C, and D jacks.

Power Connection

Power Cable Connection Steps

Steps to connect the power cable to the module and power supply system, including safety precautions.

Installation

Mounting in Eurorack Case

Procedure for securely mounting the module into a Eurorack case using provided screws.

Specifications

Signal Input and Output

Details on signal input/output type, impedance, and maximum levels.

Gate Control Specifications

Specifications for gate control type, impedance, and switching threshold.

Multiples and Power Details

Specifications for multiples, power supply, and current draw.

Physical Characteristics

Physical dimensions, rack units, and weight of the module.

Behringer 173 QUAD GATE/MULTIPLES Specifications

General

Brand	Behringer
Model	173 QUAD GATE/MULTIPLES
Category	Recording Equipment
Language	English