Installation
The necessary screws are included with the module for mounting in a Eurorack case. Connect the power cable before mounting. !
Depending on the rack case, there may be a series of fixed holes spaced 2 HP apart along the length of the case, or a track that allows
individual threaded plates to slide along the length#
of the case. The free-moving threaded plates allow precise positioning of the module, but each plate should be positioned in the
approximate relation to the mounting holes in your module before attaching the screws. !
Hold the module against the Eurorack rails so that each of the mounting holes are aligned with a threaded rail or threaded plate. Attach
the screws part way to start, which will allow#
small adjustments to the positioning while you get them all aligned. After the final position has been established, tighten the screws
down. !
To Next Page
Loading...
