Set up
1. Charge unit min 48 hours before event.
a. Connect power cord to unit and leave off to charge.
2. Set up speaker stand or set system on a solid surface.
3. Using wireless mic inset transmitter that cooresponds to mic or mics being used into
USB port.
4. Turn power on, if using 120V connect power cord and plug into power source.
5. USB transmitter should be blinking.
6. Turn wireless mic on by pressing up button and holding until solid. Mic is linked to
transmitter.
a. If using dual mic will have to do for both mics.
7. Connecting bluetooth to laptop or mobile phone. On top of MPA 100 press bluetooth
button. It will start blinking find on mobile device and select. The bluetooth button
should be solid and mobile device should show it is link to speaker.
Operation
1. Turn Power on to unit
2. Link up wireless Mics
3. Adjust mic gain
4. Adjust computer/mobile phone input gain if used
5. Adjust overall master volume
6. As speaker speaks should see indication on LEDs for each wireless mic.
7. Bluetooth automatically links to someone else phone, press and hold bluetooth button
until it is blinking then reselect with correct device. This will also disconnect a device.
8. Each mic has an up and down control. This allows speaker to adjust level. If the down
button is held mic will mute and show by having a blinking LED. If down button is
continued to be depress mic will turn off. To turn back on press up button. If mic is turn
off and back on the it will remember the bluetooth link.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
