10
volume and the Channel volume, are set below or around 0 (unity gain), lower the instrument / FX unit output
level.
5.4 2-Track Input / Main Mix Output
Input
A 2-Track Input, on RCA phono jacks, provides easy connection to DAT and other professional and semi-
professional audio equipment. The 2-Track Input is primarily for auditioning mix playback from tape. Switch
2TK TO CTRL ROOM routes this signal to the studio monitors. However, it can also be routed to the Main
Mix via switch 2TK TO MIX. Here should be disengaged, or you will be listening to the 2-Track signal
twice over! With depressed you have another Stereo Line Input available to the mix.
Tip: The 2-Track Input could be normalled to the output of a HiFi pre-amp, allowing you to monitor extra
sources such as vinyl, cassette, CD etc.
Output
A single pair of unbalanced TS jacks deliver the Main Mix output to your 2-Track recorder (or PA system). RCA
phono jack outputs are also provided for easy connection to DAT, cassette desk etc.
Level is ultimately determined by a precision Main Mix volume control .
5.5 Monitoring
A single volume control sends the level to the headphones and main monitors.
The L/R meters follow the Main Mix.
6. CONNECTIONS
You will need a lot of cables for different purposes - see the following figures to make sure you have got the right
ones. Unbalanced equipment may be connected to balanced inputs/outputs. Either use mono 1/4" jacks or
connect ring and sleeve of TRS jacks.
Fig. 6.1: Headphone connection
Phantom power (+48 V DC) is provided. This can be switched on or off by the +48 V Phantom switch .
6. CONNECTIONS
To Next Page
Loading...
