Need help?Do you have a question about the Behringer FEEDBACK DESTROYER PRO DSP1124P and is the answer not in the manual?
General| Type | Feedback Destroyer |
|---|---|
| Number of Channels | 2 |
| Frequency Range | 20 Hz - 20 kHz |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Input Impedance | 20 kΩ |
| Maximum Input Level | +22 dBu |
| Maximum Output Level | +22 dBu |
| Rack Spaces | 1U |
| Input Connectors | XLR, 1/4" TRS |
| Output Connectors | XLR, 1/4" TRS |
| Mounting | Rackmount |
| Power Supply | 100-240 V AC, 50/60 Hz |
Essential warnings regarding electrical shock and fire hazards.
Comprehensive instructions on water, ventilation, heat, power, grounding, and cleaning.
Highlights automatic feedback detection, parametric filters, and operating modes.
Guidelines for setting input levels and using the device in monitor paths.
Describes usage in Front of House systems and home/studio recording environments.
A concise guide for initial feedback suppression setup before a performance.
Details the Jog Wheel, Filter Select, Filter Mode, Frequency, Fine, Bandwidth, and Gain controls.
Details the four primary operating modes for individual filters.
How to change filter operating modes (SI, AU, PA, OF, LO) for presets.
Advice on common causes of feedback and preventative measures.
To Next Page
