Operating Instructions
HBP530A-CNC
BA85308
Status 46/04
Rev 07.02.11
Page 19
4.19 Cope devise (optional equipment)
This devise serves for coping the material during manual operation.
Manual cope: Adjusting the coping height with a ruler at the saw frame.
Electronical cope: Entering the coping height at the operation panel at page 27 “common
sawing” “coping at: …. mm”. If the value “000” is entered, then it is sawed through totally. If
a value higher “000” is entered then it will sawed until this position and the machine is
switch off.
To Next Page
Loading...