Behringer HBP530A-CNC - Fault messages; Safety device;guards; Wheel cover; Motor overloads

Operating Instructions
HBP530A-CNC
BA85308
Status 46/04
Rev 07.02.11
Page 4
8
Fault messages 101
9 Safety device/guards 117
9.1 Wheel cover 117
9.2 Motor overloads 117
9.3 Band slip monitor 117
9.4 Breakage band control 117
9.5 Band deflection monitor (Specific equipment) 117
9.6 Coolant flow monitor (Specific equipment) 117
9.7 Coolant level monitor (Specific equipment) 117
9.8 Band location monitor (Specific equipment) 118
9.9 Protective fence (Specific equipment) 118
9.10 Light barrier (Specific equipment) 118
10 Maintenance 119
10.1 Coolant 119
10.2 Grease lubrication 119
10.3 Gear box 119
10.4 Hydraulic 119
10.5 Chip brush 120
10.6 Carbide blade guides 120
10.7 Wheel cases 120
10.8 Chip conveyor (Specific equipment) 120
10.9 Measuring unit (Specific equipment) 120
10.10 Change of battery 120
10.10.1 Operation steps 121
10.11 Preplacement and Cleaning of Filter Mat 121
10.12 Lubricants 122
11 Troubleshooting 123
12 Ex-operation 124
13 Appendix 124
13.1 Feed in relation to the current regulator position 125
14 B EHRINGER -Cool Jet Lubricate Device (Special Equipment) 126
14.1 Safety 126
14.2 Operation 126
14.2.1 Fundamental function description 126
14.2.2 Switch on and - off of the spray cooling 126
14.2.3 Calibration of the spray jet 126
14.2.4 Calibrate working air pressure 127
14.2.5 Calibrate delivering volume 127
14.2.6 Calibrate spray air volume 127
14.2.7 Proof calibration 127
14.3 Refilling lubricant 127
14.4 Determine the spray stuff consumption 129
14.5 Choice of a spray stuff 130