Behringer Microamp HA400 - Page 31

31
MICROAMP HA400
(1) Connect the power supply unit to your HA400 using the 12 V
connector. Connectingthe power supply unit to the mains
automatically switches the HA400 on. Todisconnect the unit
from the mains, pull out the main cord plug.
◊ ◊ When installing the product, ensure that the plug is
easily accessible. Ifmounting in a rack, ensure that the
mains can be easily disconnected by a plug or by an all-
pole disconnect switch on or near the rack.
(2) Connect up to 4 headphones to these ¼" TRS connectors.
(3) The signal source has to be connected to this ¼" TRS connector
(INPUT).
◊ ◊ In case the volume level of the signal source is set too
high, the HA400 may produce distortion!
(4) This ON LED is illuminated as soon as the unit is connected to
the power.
(5) Using the LEVEL controls you can set the volume of each
headphone output.
◊ ◊ High volume levels can damage your hearing or your
headphones. Pleaseturn down all volume controls
to zero (allthe way to the left) beforeyou power
up the amp. Always make sure you use appropriate
volumelevels.
SERIAL NUMBER. The serial number of the HA400 is located at
thebottom.