Behringer MICROMON MA400 - Monitor Input Connector; Headphone Output Connectors; Mic Level Control; Monitor Level Control

3
MICROMON MA400
(6) MONITOR INPUT connector: To send a signal from a mixer or
Hi-Fi unit to the MA400, you need an audio cable that includes
¼" connectors (unbalanced/stereo TRS or unbalanced/mono TS).
Plug:
•
• one XLR connector into the MIC INPUT connector
•
• the other ¼" connector into the AUX SEND of a mixer or,
alternatively the output of a Hi-Fi unit
(7) ¼" PHONES connector, (8) ⁄" PHONES connector:
To connect headphones to the MA400, use the ¼" or,
alternatively the ⁄" PHONES connector.
◊
◊ Do not simultaneously use both PHONES connectors.
(9) MONO / STEREO switch: To specify the type of mixer or Hi-Fi
signal the MA400 receives, use this switch. If you plugged:
•
• a TS connector into the MONITOR INPUT, the MA400
receives a mono signal. Pushthis switch to MONO.
•
• a TRS connector into the MONITOR INPUT, the MA400
receives a stereo signal. Push this switch to STEREO.
(10) MIC LEVEL control: To adjust the volume of the microphone
signal, slowly turn this control toward 0 (minimum volume) or,
alternatively 10 (maximum volume).
(11) MON LEVEL control: To adjust the volume of the mixer or Hi-Fi
signal, slowly turn this control toward 0 (minimum volume) or,
alternatively 10 (maximum volume).
SERIAL NUMBER: To register your unit, use the serial number
that is located on the bottom of the MA400.