Behringer NR300 - Safety Instructions; Limited Warranty; Specifications

2 NOISE REDUCER NR300
(8) The ¼" TS OUT connector sends the signal to your amp.
(9) Use this ¼" TS SEND connector to connect it to the input
of an external eect unit. This way you can feed in an eect
signal while simultaneously eliminating noises from the unit.
(10) The ¼" TS RETURN connector is used to feed in the external
eect signal.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery (not included), press the hinges
with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
◊ ◊ The NR300 has no on/o switch. As soon as you insert the
jack into the in connector, the NR300 begins running.
When not using the NR300, remove the jack from the in
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualied servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
3. Limited Warranty
For the applicable warranty terms and conditions and additional
information regarding Music Tribe’s Limited Warranty, please see
complete details online at community.musictribe.com/pages/
support#warranty.
4. Specications
In
Connector ¼" TS
Impedance 500 k
Out
Connector ¼" TS
Impedance 1 k
Send
Connector ¼" TS
Impedance 1 k
Return
Connector ¼" TS
Impedance 50 k