1. The POWER switch turns the amplifier on.
2. Connect your bass guitar to the INPUT jack using a ¼” mono plug (unbalanced).
3. The GAIN 1 knob adjusts the input gain for channel 1.
4. The CH 2 button switches between channel 1 and channel 2. This can also be done using the included
footswitch.
5. The GAIN 2 knob adjusts the input gain for channel 2. As you turn the knob clockwise, the distortion effect is
continuously blended in.
6. The SHAPE knob adjusts which frequencies are scooped out of your bass tone. It only affects channel 2.
7. The LEVEL knob adjusts the volume of channel 2. Use this control to balance the volume between channels 1
and 2.
8. The FBQ EQUALIZER has 7 slide controls, one for each frequency band. The maximum boost/cut is 12 dB.
9. The FBQ switch activates the FBQ spectrum analyzer. The control LEDs, normally identical when FBQ is off,
now show the energy content of each frequency band with a corresponding degree of brightness. The equalizer
is always active regardless of the FBQ function.
10. The COMPRESSOR knob controls the compression intensity.
11. Push this ON button to activate the compressor for both channels. The LED in the button will light up to indicate
the compressor is on.
12. The ULTRABASS control allows you to add ultra-low frequencies one octave below your bass signal. The
ULTRABASS effect is available for both channels.
13. Push this ON button to activate the ULTRABASS function. The LED in the button will light up to indicate
ULTRABASS is on. You can also control this effect with the included footswitch.
14. Use the MASTER control to set the overall volume.
15. The PHONES jack is for connecting a pair of headphones.
16. Power is supplied via the included IEC connector.
To Next Page
Loading...
