12
V-AMP 2
2.3 Recording
A widely used recording application is to make a “dry” recording of the output signal while monitoring the
signal with effects (“wet”). The advantage here is that you don’t have to make a final decision on what effect
to use during mix-down. For this purpose connect the left output of the V-AMP 2 to the recording device, and
use the right output for monitoring.
If you have a MIDI foot controller, you can use it to control preset, bank and amp model changes. It’s also
convenient for switching the tuner on and off.
Fig. 2.2: Recording situation
For this application please select CONFIGURATION mode S2!
2.4 Live set-up with an external guitar amp
When you’re playing on stage it’s extremely important that you are able to hear your guitar properly. It’s an
advantage to use a guitar amp with a line input, like the BEHRINGER BLUE DEVIL GX112. Apart from that,
the amp used should provide enough power to reproduce the V-AMP 2’s sound potential to the full.
Fig. 2.3: Live set-up with external guitar amplifier
2. EXAMPLES OF USE/CONFIGURATIONS
To Next Page
Loading...
