7
V-AMP 2
1.2 Before you begin
Your V-AMP 2 was carefully packed before it left the factory to protect it from damage in transit. If there are
signs of damage on the packaging, we recommend that you immediately examine the device itself for further
signs of damage.
+ In case of damage, do NOT return this device to us, but immediately notify your dealer and the
transport company, as any entitlement to damages may otherwise be lost.
A power supply unit which meets the necessary safety requirements is enclosed for connecting the V-AMP 2
to the mains. When the V-AMP 2 is connected to the mains via the power supply unit it is automatically
switched on.
+ Never connect the V-AMP 2 to a power supply unit that is already plugged into the mains!
Always connect the V-AMP 2 to the power suply unit first and then plug it into the mains.
The MIDI connections (IN/OUT) are for standard DIN connectors. Data is transferred at zero potential via an
optocoupler. Please read chapter 7 INSTALLATION for further information.
1.2.1 Serial number
The V-AMP 2s serial number is located on the rear side. In order to qualify for extended warranty entitlement,
please return the completed warranty card to us within 14 days of purchase, or simply register on-line
(www.behringer.com).
1.3 Control elements
1.3.1 User interface
Fig. 1.1: Control elements on the user interface
1. INTRODUCTION
To Next Page
Loading...
Need help?
General
