BEKA Yarn Swift - User Manual

To Next Page

Beka, Inc. • 542 Selby Avenue • St. Paul, Minnesota 55102 • USA

1-888-999-2352 • www.bekainc.com • 651-222-3965 fax

Yarn Swift

Parts:

-base assembly

-2 long bars (bottom cross) to support dowels

-1 center post with hanger bolts in each end

-2 short bars (top cross) with notches to hold dowels

-1 washer and knob with metal inset

-4 dowels

-4 adhesive-backed rubber feet

Assembly Instructions:

Fig. 1

Step 2)

Holding the center post, orient the assembly so

the base is above the post and cross bars (fig. 2).

Position the center post so it engages the shallow

notch where the cross bars intersect. Turn the

base assembly so the hanger bolt tightens into the

metal insert in the base. Snug the cross bars

against the base.

Attach a rubber foot to the bottom side of each

base assembly cross piece, about an inch from the

end. Press to secure the adhesive.

Fig. 2

Step 1)

Place the base assembly on a table top or floor,

with the solid wood piece up, as shown in fig. 1.

Position the long bars so their center notches in-

terlock. Orient them above the base assembly so

the holes near each end face up. Insert the hanger

bolt in one end of the center post through the

cross bars and engage the metal insert in the base

assembly; do not tighten—see next step.

Step 3)

Re-position the base on a table or floor, so the

center post sticks up. You can position the cross

bars against the base assembly as shown; specific

positioning does not effect function as long as the

bars are snug to the surface of the base assembly.

Fig. 3

Need help?

Do you have a question about the BEKA Yarn Swift and is the answer not in the manual?

Summary

Yarn Swift Assembly Instructions

Step 1: Base Assembly Setup

Position the base assembly, interlock the long bars, and insert the center post.

Step 2: Cross Bar Alignment and Securing

Align the center post with cross bars and tighten the base; attach rubber feet.

Step 3: Final Base Positioning

Re-position the base and ensure cross bars are snug against the base assembly.

Step 4: Top Cross Bars and Knob Installation

Interlock short cross bars, slide onto post, and secure assembly with knob.

Step 5: Dowel Placement

Position dowels into the cross bars to hold yarn securely.

Step 6: Swift Ready for Use

Swift is assembled; notes on maintenance and oiling for smooth turning.

Yarn Swift Usage Instructions

Using the Yarn Swift

Guide on positioning yarn, winding skeins, and general operation of the swift.