Why my Beko ATH8130 Humidifier cannot start?
If your Beko Humidifier isn't starting, there could be a couple of reasons. First, check the power supply to ensure there is electricity in the socket. If there is power, make sure the humidifier is properly plugged in. If it is not, re-plug it.
What to do if Beko ATH8130 has water leakage in use?
If your Beko Humidifier is leaking water during use, make sure that it is placed on a flat surface. Ensure smooth and steady moving when the humidifier is in use or being moved.
Why no air comes out of my Beko ATH8130 Humidifier?
If no air is coming out of your Beko Humidifier, the air inlet or outlet may be blocked. Remove any blockage that you find. If there is no blockage, the motor might not be working; in that case, contact the after-sale service.
How to get rid of unpleasant odor from Beko Humidifier during humidification?
An unpleasant odor during humidification with your Beko Humidifier might be due to a dirty trough or stagnant water in the tank. Follow the cleaning and maintenance procedures to resolve this issue, and ensure you change the water in the tank every day.
Why humidity doesn’t increase with Beko ATH8130?
If the humidity isn't increasing with your Beko Humidifier, it might be because the room is ventilated or has carpet on the floor. Due to ventilation, different floor and wall textures, it can sometimes be hard to increase humidity if the room has carpet.
What to do if the indicator light keeps flickering on my Beko ATH8130?
If the indicator light on your Beko Humidifier is flickering even when the tank has water, it could be that the trough components are not properly installed. Assemble the trough components according to the installation requirements.
Why does my Beko ATH8130 stop after working for a while?
Your Beko Humidifier can monitor real-time humidity. It is normal for the machine to stop working once the humidity reaches the set point.
Why is cold wind generated by Beko Humidifier during humidification?
When your Beko Humidifier is in sleep or standard humidification modes, moisture is sent out from the hole of the wheel, which can absorb heat in the air, so the generated wind may be colder than room temperature.
General| Model | ATH 8130 |
|---|---|
| Type | Ultrasonic |
| Humidification Capacity | 300 ml/h |
| Timer | Yes |
| Auto Shut-off | Yes |
| Noise Level | 35 dB |
| Dimensions | 20 x 20 x 30 cm |
To Next Page