Why Beko BDIS38120A does not start?
Your Beko dishwasher might not be starting due to several reasons. First, check if the power cable is properly plugged in. Also, verify that the fuse in your house hasn't blown. Ensure that the water supply is on by checking the water inlet tap. Make sure the dishwasher door is fully closed and that you have pressed the On/Off button to turn the machine on.
What to do if Beko BDIS38120A leaves dishes not washed clean?
If your Beko dishwasher isn't cleaning dishes properly, consider these points: * Ensure dishes are loaded correctly as described in the manual. * Select a more intensive programme with a higher temperature. * Check that impellers rotate freely and aren't blocked by food remnants; clean them regularly. * Inspect and clean the filter system, ensuring it's correctly installed. * Avoid overloading the baskets. * Store powder detergent properly in a closed container and use enough detergent or switch to tablet detergents. * Check and refill rinse aid if needed, and ensure the detergent dispenser lid is closed tightly.
What to do if water remains in Beko Dishwasher at the end of the programme?
If water remains in your Beko dishwasher after the cycle, check if the filter system or the discharge hose is clogged or blocked. Clean the filter system and, if necessary, remove the discharge hose to clear any blockages.
What to do if Beko BDIS38120A leaves detergent remains in detergent dispenser?
If detergent remains in the dispenser of your Beko dishwasher, make sure the dispenser was dry when you added the detergent and that you're adding detergent shortly before starting the wash. Ensure dishes aren't blocking the dispenser lid from opening during washing. Also, ensure that you are not storing powder detergent in humid conditions and that the impeller holes are not clogged.
Why Beko Dishwasher leaves dishes scratched?
Scratched dishes from your Beko dishwasher can be due to a few reasons. Salt leakage can cause scratches, so be careful when filling the salt reservoir, ensure the lid is tightly closed, and run a prewash cycle to remove any spilled salt. Also, check that your water hardness setting is correct and the salt level is sufficient. Finally, make sure that glasses and glassware are placed so they don't strike each other during the wash cycle.
General| Appliance placement | Built-in |
|---|---|
| Energy Efficiency Class | A++ |
| Number of Place Settings | 11 place settings |
| Noise Level | 48 dB |
| Height | 81.8 cm |
| Width | 59.8 cm |
| Depth | 55 cm |
| Control panel colour | Black |
| Delayed start timer | Yes |
| AquaStop function | Yes |
| Energy Rating | E |
| Delay Start | Yes |
| Half Load | Yes |
| Wash Programs | Eco, Intensive, Quick |
| Drying system | Static |
| Delay start (max) | 9 hours |
| Programs | Eco, Intensive, Quick |
To Next Page
