Beko UFF4584W - Installation; Transportation Instructions; Installation Instructions

EN
9
3 Installation
Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the front of the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. Empty any water in the drain
tray before moving see section
“Defrosting” and “Cleaning & Care” for
further information
Important :
Make sure the plastic evaporating
pan at the back of the product collects
water properly.
Important:
Care must be taken whle cleanng
/ carryng the applance to avod
touchng the bottom of the condenser
metal wres at the back of the
applance as you mght njure your
fngers and hands.
Important:
Ths applance s not desgned for
stackng wth any otherapplance.
When postonng your applance,
take care not to damage your floorng,
ppes,wall coverngs etc. Do not move
the applance by pullng by the door or
handle.Do not attempt to st or stand
on top of your applance as t s not
desgned for such use. You could njure
yourself or damage the applance.
Important:
Make sure that mans cable s not
caught under the applance durng and
after carryng / movng the applance,
to avod the mans cable becomng cut
or damaged.”Do not allow chldren to
play wth the applance or tamper wth
the controls.
BEKO declines to accept any liability
should the instructions not be
followed.
Installation Instructions
1. If possible avoid placing the
appliance near cookers, radiators or in
direct sunlight as this will cause the
compressor to run for long periods. If
installed next to a source of heat or
refrigerator, maintain the following
minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge
1” (25 mm)
2. No gap is required at sides
and top. See item 3 below to ensure
a gap is obtained at the rear of the
appliance. If a gap is available on
side and top, retain it if possible as
it would improve the air circulation
around the appliance.