Why does my Beko Washer product directly drain the water it takes in?
If your Beko Washer is immediately draining the water it takes in, the draining hose may not be at an adequate height. Connect the water draining hose as described in the user manual.
What to do if my Beko WEY106052W Washer is leaking water from the bottom?
If you notice water leaking from the bottom of your Beko Washer, it could be due to: * A clogged or twisted water drain hose; clean or flatten the hose. * A clogged pump filter; clean the pump filter.
Why won't my Beko WEY106052W Washer loading door open?
The loading door of your Beko Washer might not open because: * The loading door lock is activated due to the water level; drain the water by running the Pump or Spin programme. * The product is heating water or is at the spinning cycle; wait until the programme completes. * The loading door may be stuck due to pressure; grab the handle and push and pull the door to release it. * There is no power; open the pump filter cap and pull down the emergency handle at the rear of the cap. See "Loading door lock".
Why won't my Beko WEY106052W take water in?
If your Beko Washer isn't taking in water, check these: * Ensure the tap is turned on. * See if the water inlet hose is bent; flatten it if it is. * The water inlet filter may be clogged; clean the filter. * Make sure the loading door is closed properly.
What to do if my Beko Washer programme cannot be started or selected?
If you cannot start or select a programme on your Beko Washer, it may have switched to self-protection mode because of a supply problem like line voltage or water pressure issues. To cancel the current programme, turn the Programme Selection knob to select another programme. The previous programme will then be cancelled. (see.“Cancellation of programme”)
Why does too much foam form inside my Beko WEY106052W?
Excessive foam inside your Beko Washer can be due to: * Using improper detergents for washing machines; use appropriate detergents. * Using too much detergent; use only a sufficient amount. * Detergent stored improperly; store in a closed, dry location away from heat. * Washing meshed laundry like tulle; use smaller amounts of detergent. * Detergent placed in the wrong compartment; use the correct compartment. * Softener being taken early; there may be a problem in the valves or detergent drawer. Call the Authorised Service Agent.
Why does my laundry become stiff after washing in my Beko Washer?
Laundry can become stiff after washing in your Beko Washer if: * Insufficient detergent is used for the water hardness; use an appropriate amount. * Detergent was put in the prewash compartment although prewash cycle is not selected; put the detergent in the correct compartment. * Detergent was mixed with the softener; do not mix and clean the drawer with hot water.
Why is there detergent residue in the detergent drawer of my Beko WEY106052W?
Detergent residue in the detergent drawer of your Beko Washer can occur if: * Detergent was put in a wet drawer; dry the drawer before adding detergent. * Detergent has gotten damp; store detergents properly. * Water pressure is low; check the water pressure. * The detergent in the main wash compartment got wet while taking in the prewash water. Holes of the detergent compartment are blocked; check and clean the holes if clogged. * There is a problem with the detergent drawer valves; call the Authorised Service Agent. * Detergent was mixed with the softener; do not mix and clean the drawer with hot water. * Regular drum cleaning is not applied; clean the drum regularly. See "Cleaning the loading door and the drum".
Why does my Beko WEY106052W Washer programme time not countdown? (On models with display)
If the programme time isn't counting down on your Beko Washer (models with a display), it could be because: * The timer may stop during water intake until the product takes in enough water. * The timer may stop during the heating step until the product reaches the selected temperature. * The timer may stop during the spinning step due to the automatic unbalanced load detection system being activated.
Why doesn't my laundry smell like softener after washing in my Beko Washer?
If your laundry doesn't smell like softener after washing in your Beko Washer: * Detergent might have been put in the prewash compartment, even though a prewash cycle wasn't selected. In this case, put the detergent in the correct compartment, and wash and clean the drawer with hot water. * Detergent may have been mixed with the softener; do not mix them, and wash the drawer with hot water.
To Next Page
General
