1. Assembly
a. Install the Belair 3000 like a conventional toilet seat: If necessary,
first remove the old seat by loosening the screws on the sides of the
toilet bowl (down below).
b. Place the Belair 3000 on the toilet bowl and insert the eccentric
screws (8) provided with the assembly kit through the eyes on the seat
holder (7) and then through the holes in the toilet bowl.
c. Before tightening the Belair screws with the provided nuts, make
sure the sensor on the underside (4) is in contact with the rim of the
toilet bowl when the seat (1) is lowered. If not, reposition the device
until this is the case. Now tighten the nuts very firmly.
d. Connect the device to the power supply by inserting the power
adapter into a power socket. If no power socket is available in the toilet
room, you can run the cable under the door to the outside and connect
it to a standard extension cord if required.
If necessary, use self-adhesive cable holders to guide the cable along
the wall.
Note: Do not leave any sections of the cable lying unsecured on the
floor, as this would constitute a risk of falling and damage the device
To Next Page
Loading...