15. After sewing has been completed, cut the thread(s) off using the cutter (21) mounted on the
left hand side of the machine by looping over the cutter and pulling down.
Reverse Sewing
Reverse sewing can be used for back tacking and reinforcing seams.
To sew in reverse, push the reverse sewing lever (2) down and hold it in position while you
press the foot controller (16). To sew forwards, release the reverse sewing lever.
Accessory Compartment
Use the accessory compartment (24) mounted at the side of the appliance to store bobbins,
spare needles or the needle threading tool.
Straight Stitching
Stitch Name Pattern
Straight stitch 1 2 3
Starting Sewing
1. Turn the pattern selection dial to choose the stitch number you want. You also need to set
the pattern selection dial to the Straight Stitch or Triple Stretch Stitch.
2. Raise the needle to its highest position and lift the presser foot lever.
3. Pull the upper thread through the toes of the presser foot.
4. Put the fabric under the presser foot and position the needle 1cm (3/8 inch) from the edge of
the fabric.
5. Lower the presser foot.
BEL0050 Sewing Machine
18
To Next Page
Loading...