What to do if Bell and Gossett ecocirc XL has a power failure?
If the Bell and Gossett Power Pump experiences a power failure, ensure that the power supply is working correctly and check the circuit breaker.
Defines hazard levels, categories, and specific safety symbols used in the manual.
Details electrical safety precautions, wiring, and connection checklists.
Covers grounding (earthing) and power supply connection steps.
Details various control modes, features like night set back, and optional sensor inputs.
Guides on changing communication parameters, control mode, set point, and display units.
Methods to start/stop the pump and details on automatic air venting procedures.
Lists fault and error codes, their causes, and suggested solutions.
Details specific alarm codes, their causes, and recommended actions.
Troubleshooting guide for common issues like pump not starting or overheating.
General| Category | Power Pump |
|---|---|
| Max Head | 60 feet |
| Motor Type | ECM (Electronically Commutated Motor) |
| Phase | Single |
| Maximum Working Pressure | 175 psi |
| Connection Type | Flanged |
To Next Page
