Bell BHT-206L3-FM-1 LongRanger-III User Manual

COPYRIGHT NOTICE
COPYRIGHT 2005
BELL
® HELICOPTER TEXTRON INC.
AND BELL HELICOPTER TEXTRON
CANADA LTD.
ALL RIGHTS RESERVED
BHT-206L3-FM-1
MODEL
206L3
28 OCTOBER 1992
REVISION 6 — 26 APRIL 2005
ROTORCRAFT
FLIGHT MANUAL
THIS MANUAL SHALL BE IN THE HELICOPTER DURING ALL OPERATIONS
BHT 51001 THROUGH 51612

Bell BHT-206L3-FM-1 LongRanger-III Specifications

General

Brand	Bell
Model	BHT-206L3-FM-1 LongRanger-III
Category	Toy
Language	English

Summary

Section 1 Limitations

1-6. Limitations: Weight/CG

Outlines weight and center of gravity considerations.

1-8. Limitations: Center of Gravity - Longitudinal

Defines longitudinal CG limits and pilot responsibilities.

1-9. Limitations: Center of Gravity - Lateral

Defines lateral CG limits.

1-11. Limitations: Airspeed

Lists approved airspeeds for various conditions.

1-17. Limitations: Powerplant

Identifies the powerplant model.

1-18. Limitations: Gas Producer RPM

Outlines G.P. RPM operating limits.

1-19. Limitations: Power Turbine RPM

Outlines P.T. RPM operating limits.

1-20. Limitations: Turbine Outlet Temperature (TOT)

Specifies TOT limits and warnings.

1-21. Limitations: Engine Torque

Outlines engine torque limits and warnings.

1-22. Limitations: Fuel Pressure

Specifies fuel pressure operating limits.

1-23. Limitations: Engine Oil Pressure

Specifies engine oil pressure limits.

1-24. Limitations: Engine Oil Temperature

Specifies engine oil temperature limits.

1-28. Limitations: Transmission Oil Pressure

Specifies transmission oil pressure limits.

1-29. Limitations: Transmission Oil Temperature

1-31. Limitations: Rotor RPM - Power On

1-32. Limitations: Rotor RPM - Power Off

Section 2 Normal Procedures

2-2. Normal Procedures: Operating Limitations

2-4. Normal Procedures: Takeoff and Landing Data

2-5. Normal Procedures: Weight and Balance

2-6. Normal Procedures: Preflight Check

2-16. Normal Procedures: Interior and Prestart Check

2-17. Normal Procedures: Engine Starting

Detailed procedure for starting the engine.

2-18. Normal Procedures: Preliminary Hydraulic Systems Check

2-19. Normal Procedures: Engine Runup

2-20. Normal Procedures: Hydraulic Systems Check

2-21. Normal Procedures: Before Takeoff

2-22. Normal Procedures: Takeoff

2-23. Normal Procedures: In-Flight Operations

2-24. Normal Procedures: Descent and Landing

2-25. Normal Procedures: Engine Shutdown

Procedure for engine shutdown.

Section 3 Emergency and Malfunction Procedures

3-5. Emergency Procedures: Engine Fire During Start or Shutdown

Procedure for engine fire during start or shutdown.

3-6. Emergency Procedures: Engine Fire During Flight

Procedure for engine fire during flight.

3-7. Emergency Procedures: Engine Failure - Hovering in Ground Effect

Emergency procedure for engine failure in hover.

3-8. Emergency Procedures: Engine Failure - Out of Ground Effect

Emergency procedure for engine failure out of hover.

3-9. Emergency Procedures: Engine Restart

Procedure for attempting engine restart in flight.

3-10. Emergency Procedures: Engine Overspeed

Emergency procedure for engine overspeed.

3-11. Emergency Procedures: Engine Underspeed

Emergency procedure for engine underspeed.

3-12. Emergency Procedures: Engine Compressor Stalls

Emergency procedure for compressor stalls.

3-13. Emergency Procedures: Engine Oil Pressure Low, High, or Fluctuating

3-14. Emergency Procedures: Engine Oil Temperature High

3-15. Emergency Procedures: Hydraulic System Failure

Emergency procedure for hydraulic system failure.

3-16. Emergency Procedures: Tail Rotor Failures

3-17. Emergency Procedures: Complete Loss of Tail Rotor Thrust

Emergency procedure for total tail rotor failure.

3-18. Emergency Procedures: Fixed Pitch Failures

Emergency procedure for fixed pitch failures.

3-19. Emergency Procedures: Electrical Failures

3-20. Emergency Procedures: Generator Failure

3-21. Emergency Procedures: Excessive Electrical Load

3-22. Emergency Procedures: Fuel Transfer Failure

Section 4 Performance

4-1. Performance: Power Assurance Check

Procedure for checking engine power assurance.

4-2. Performance: Density Altitude

4-3. Performance: IGE and OGE Hover Ceilings

4-4. Performance: Rate of Climb

Explains rate of climb charts.

4-7. Performance: Height-Velocity Diagram