Need help?Do you have a question about the Bell 206L-1 and is the answer not in the manual?
Specifies approved cargo types, load combinations, and adherence to national operational requirements and FAR Part 133.
Details placards mounted on the suspension beam assembly and cargo hook for load limits and warnings.
Outlines essential pre-flight checks for cargo hook fasteners, electrical connectors, and release systems.
Provides guidance on rigging loads to the cargo hook, highlighting potential difficulties and caution for operators.
Warns about un-commanded release caused by load rings that are too large, detailing how they flip and gyrate.
Warns about load hang-up from load rings that are too small or from using multiple rings on the load beam.
Advises against using nylon straps directly on the load beam due to creep; recommends attachment to a primary ring.
Warns against using cable or rope straps directly on the load beam; recommends attachment to a primary ring.
Explains adverse loading from angles exceeding 55°, stressing the load cell and recommending avoidance of such flight regimes.
To Next Page
General
