Document Number
121-044-00
Bell 206L/407 Cargo Hook Kit
Rotorcraft Flight
Manual Supplement
1-20 Placards continued
When an Onboard Systems kit P/N 200-196-00 is installed the
following placards apply.
Mounted adjacent to the Onboard Systems load weigh indicator
in full view of pilot or co-pilot:
Mounted adjacent to the power switch and the circuit breaker
in full view of the pilot and co-pilot.
2. NORMAL PROCEDURES
2-3 Pre-flight Check
Consult the Rotorcraft Flight Manual Supplement – Cargo
Hook issued by Bell Helicopters for additional procedures.
Before each Cargo Hook use perform the following
procedures. If the procedures are not successful do not use the
equipment until the problem has been corrected.
1. Inspect all cargo hook fasteners to ensure that they are
tight.
2. Visually inspect the electrical connector for damage and
security.
3. Operate the cargo hook keeper manually and check that it
snaps back to its normal position on the load beam.
TURN THE WEIGHING SYSTEM OFF WHEN
NAVIGATION EQUIPMENT IS IN USE. NO AIRCRAFT
OPERATION SHOULD BE PREDICATED ON THE
READING OF THE ONBOARD WEIGHING SYSTEM.
ELECTRONIC WEIGHING SYSTEM
To Next Page
Loading...
Need help?
General
