5
BEFORE USING FOR THE FIRST TIME
1. Carefully unpack the can opener and remove all packaging materials. Check the contents to ensure
that all parts are present, and have been received in good condition.
2. Handle the blade bracket with care. The cutting blade is sharp.
4. The motor base may be wiped with a damp cloth.
ASSEMBLY INSTRUCTIONS
1. Attach blade bracket to the can opener by aligning the key tabs with the key slots. Push the blade bracket in.
(see Fig. 2).
2. Press the bracket down to ensure the blade bracket has been properly assembled (see Fig. 3).
OPERATING INSTRUCTIONS
Can Opener
electrical outlet.
2. Tip the can forward so that its rim is under
the locating post and against the drive wheel.
Press down the blade bracket and make sure
the blade is inside the rim (see Fig. 4).
3. The can will rotate and the blade will cut the can
lid open. Because of the hands-free feature, it is not
necessary to hold blade bracket down or support
the can during cutting.
NOTE: In case the total weight of a can is over
21oz, it is necessary to press and hold the can
opener to avoid overturning.
Note: The can required to be opened shall be
50mm to 100mm in diameter and 140mm max
in height.
4. When the can is opened, the can opener will
stop automatically. To remove the can, hold it with
one hand and raise the blade bracket with the other
one.
5. CAUTION: Avoid contact with the cut edges of
the can or lids as they are sharp, carefully remove
the lid from the magnet and discard.
NOTE: The time of continuously opening cans
should not exceed 3 minutes.
at the back of the unit. Feed the cord through the
notch for convenient storage.
Warning: The cans opened with this can opener
must be less than 21 oz in weight.
Figure 2 Figure 3
Figure 4
35195_35207_36208_35209_35210 Bella CanOpener IM V3 R0.indd 535195_35207_36208_35209_35210 Bella CanOpener IM V3 R0.indd 5 2024-09-06 9:22 AM2024-09-06 9:22 AM
To Next Page
Loading...