Bellari MT502 User Manual

MT502
SPECIFICATIONS:
I/ O Connectors: RCA
Input Impedance: 30-300 ohms
Output Impedance: 30k ohms
THD: .02% @ 1KHz
Size: 4"w x 1.1"h x 4"d
Weight: 2 lb
QUICK START GUIDE
Salt Lake City, UT
01/19
input
MT502
ratio
MADE IN USA
1:12
1:30
ground
output
lift
Moving Coil Step-up Transformer
turns
DO NOT OPEN THE MT502. NO USER SERVICEABLE PARTS ARE
INSIDE. ALL WARRANTIES ARE VOID IF ANY INTERNAL COMPO-
NENTS ARE DAMAGED DUE TO USER ERROR.

Bellari MT502 Specifications

General

Brand	Bellari
Model	MT502
Category	Amplifier
Language	English

Summary

Specifications

I/O Connectors

Type of connectors used for input and output, specified as RCA.

Input Impedance

The input impedance range for the device, measured in ohms.

Output Impedance

The output impedance of the device, specified as 30k ohms.

THD

Total Harmonic Distortion measured at 1KHz, stated as .02%.

Size

Physical dimensions of the unit: 4 inches wide, 1.1 inches high, and 4 inches deep.

Weight

The total weight of the device, specified as 2 pounds.

Connection

Input Connection

RCA connectors for connecting your turntable with a moving coil cartridge.

Output Connection

RCA connectors for connection to a phono preamp with RIAA equalization.

Ground Lift Switch

Connects or disconnects the ground connection between INPUT and OUTPUT RCA's to reduce ground loops.

Turns Ratio Switch

Selects between low output moving coil carts and very low output moving coil carts for optimal gain.

Ground Post

Connects your turntable's ground wire; may offer better results bypassing the MT502.