Bellini BTBL55 - Getting to Know Your Blender; Before First Use; Assembling the Jar; Inserting the Jar

5
Getting to Know Your
Blender
Congratulations on the purchase of your new
Blender.
Before using your new Blender, it is most
important that you read and follow the instructions
in this use & care booklet, even if you feel you are
familiar with this type of appliance.
Your attention is drawn particularly to the section
dealing with IMPORTANT SAFEGUARDS. Find
a safe and convenient place to keep this booklet
handy for future reference.
This appliance has been designed to operate
from a standard domestic power outlet. It is not
intended for industrial or commercial use.
Before First Use
•
All parts of the blender are to be thoroughly
cleaned before being used for the fi rst time.
•
Take out the required length of cable from
the cable tidy on the base of the blender and
connect the device to the mains supply.
Assembling the Jar
•
Put the rubber sealing ring (5) on the inner
edge of the blade unit (6).
•
Put the blade unit with sealing ring into the cup
base (7).
•
Insert the assembled cup base onto
the bottom of the jar and secure tightly.
•
Mount the jar(3) onto the cup base unit and
and turn clockwise until the jar locks in place.
Secure the Lid onto the Jar and press down.
Note: the safety ring (4) is fi xed on the jug
(3), do not try remove it.
Inserting the Jar
• Make sure that the blender is switched off
(Switch to the ‘0’ setting).
• Place the jar assembly (3) on to the motor
base (8) and press down until securely
engaged.
How to Use Your
Blender
•
Place the ingredients you wish to process into
the jar.
•
Put the lid on the jar and close securely. Place
the measuring cap into the hole in the lid and
turn clockwise to lock.
•
Operate the motor for a maximum of 1 minute
or alternate 1 minute on, then 3 minute off to
prevent overheating or consequent damage.
•
Switch on the motor base:
Speed
setting
Use
1
for light usage with liquids
2-5
more solid consistency – for
mixing liquids and solid foods
0
stop operation
P
for ice crushing & short,
powerful impulse movements
(The switch does not permanently engage in the
‘PULSE’ setting. You have to hold the switch in
the ‘PULSE’ setting or turn it repeatedly into the
‘P’ setting).
After using the blender, always move the switch
into the ‘0’ setting and pull out the mains plug.
To remove the glass jar simply lift it off the motor
base. You do not have to rotate the glass jar to
remove it.