Since this is a setting that will kill a variety of insects, it is best to place the unit on
a flat, hard surface. Make sure to place away from high-traffic areas and out of the
reach of children and pets.
Make sure to fill the bait tray and place the ring on the unit, as shown on previous page.
1. There are 2 openings in the base of the unit that
allow the roaches to enter. Tray with bait will trap the
roach (it will be able to get in, but not able to get out).
2. Once the unit detects a roach inside, the Roach
Mode indicator light will begin to flash. Three hours
after the first roach gets in, the heat will turn on
automatically. The Roach Mode light will continue
to flash. Heat will be generated for about 8 minutes
to kill the trapped insect(s) inside.
A. FILL THE BAIT TRAY (Roach & Both Modes)
1. Slide the bait tray out from the base of the unit.
Tray can be removed from one side only.
2. Place roach bait inside the 4 corners of the tray. You can use
pieces of banana peel, overripe fruit, or anything fragrant and
sweet. You may also use a specially designed bait (sold separately).
3. Slide the tray back inside the unit. Tray will go in one way only.
Place the unit on a flat, hard surface. Make sure to place away
from high-traffic areas and out of the reach of children and pets.
B. ASSEMBLY THE RING (Roach & Both Modes)
1. Connect both pieces of the ring to form a circle.
Snap into place. See Diagram on right.
2. Twist the top of the unit counterclockwise to
remove it. Set aside.
3. Drop the assembled ring over the lamp (with sides
pointing up). Press down to ensure a snug fit.
4. Replace the top and twist clockwise to lock it in place.
TO KILL ROACHES AND CRAWLING BUGS
HOW TO ACTIVATE
WHAT HAPPENS
Press the ON/OFF button 2 times to activate the
Roach Mode. The indicator light will turn on
(lamp will not turn on during this setting).
To turn the unit OFF at any time, press and hold
the ON/OFF button for 3 seconds.
PRESS
2 times
3. After 8 minutes, the heat will turn off and the Roach Mode light will become solid.
This completes the 1st cycle. There are a total of 3 heating cycles that will be
performed on a full charge.
Ex.: Roach gets in ----> wait 3 hours ----> 8 minutes of heating ----> heat OFF
DO NOT PLACE YOUR FINGERS/HANDS OR ANY OBJECT INSIDE THE OPENING
OF THE TRAY DURING USE.
4. If the heating function has been activated more than 3 times, you have to manually
activate it the next time a roach enters the unit (indicator light will flash). Just press
the ON/OFF button 2 times until the indicator light of the Heat mode will go on.
The heat will come on and it will automatically turn off after 8 minutes.
5. When the unit needs to be charged, the Heat light will flash. Follow the Charging
directions to charge your unit.
6. To turn the unit OFF at any time, press and hold the ON/OFF button for 3 seconds.
WHAT HAPPENS continued
TO KILL MOSQUITOES, FLYING BUGS, ROACHES, CRAWLING BUGS
PRESS
3 times
Press the ON/OFF button 3 times to activate the
Both Mode. The indicator light will turn on
and the lamp will emit the UV light.
CAUTION: When unit is used in Both Mode,
a high voltage will be produced. To reduce the
risk of injury, keep hands away from grid.
To turn the unit OFF at any time, press and hold
the ON/OFF button for 3 seconds.
HOW TO ACTIVATE
WHAT HAPPENS
1. Mosquitoes will fly towards the light and will
die when come in contact with the UV lamp.
2. There are 2 openings in the base of the unit
that allow the roaches to enter. Tray with bait
will trap the roach (it will be able to get in,
but not able to get out).
HOW TO ACTIVATE
5 6
To Next Page
Loading...