In the case of a trouble, please see troubleshooting below, so it may help you to solve the problem or to find
the solutions. The troubleshooting described speculates on various problems. If the problems or symptoms
are not listed here, please contact Takara Belmont.
CAUTION:
Please make sure disconnect power supply line before repair or replace defective parts. If not, it may cause
injury from electrical shock. Special care must be taken when repairing the chair motor, capacitor, solenoid
valve and power supply cable which parts are operated with high voltage.
High voltage parts
* Unit in j-box : power cable, power switch, fuse, air switch, terminal block, transformer, Noise filter,
900LED Power supply PCB.
* Chair : Motor, capacitor, solenoid valve, power cable, chair PCB (input voltage).
In the case of the repair of the chair hydraulic circuit. Make sure that the hydraulic circuit is not pressurized
before removing the hydraulic parts such as motor, solenoid valve and cylinder.
Remove the chair to lowest end and fully reclined position for unpressurized chair position by “LIMIT
To Next Page
Need help?
General
