2
BB-2000
Housing
Remove Screws O-Ring
• Remove the screws from the seat damper
and the side control and
remove both parts.
• Pull out the red O-Ring
• Pull out the seat & wiring through the
hole in the housing.
Tighten Screw
• Remove the screws from the part
indicated in the picture below
• From this point on, you will be able to remove
the housing and replace it with the new housing.
Repeat the steps in reverse to complete.
If there are any questions or concerns, please contact our customer support at 847.458.2334
To Previous Page
Loading...
