11 10
INSTALLATION GUIDE
Silicone Washer
Deck Plate
Above sink
Below sink
Rubber Washer
Metal Washer
Mounting Nut
Mounting Screws
Spray Hose
Outlet Hose
*For Single-Hole Install ONLY
*For Three-Hole Install ONLY
1. Single Hole or Three Hole Installation
Single Hole - Insert the silicone washer over the hoses, cable, and stem which
are located at the bottom of the faucet. Then mount the faucet onto the sink.
1. Slide the rubber washer over the hoses and data cable.
Slide the metal washer over, and lastly the mounting nut.
2. Tighten the screws with a Phillips screwdriver.
Three Hole - Insert the deck plate over the cable and hoses in the mounting
stem. Align the grooves in the deck plate with the arches on the faucet bottom.
Then mount the faucet on the sink.
1. Slide the rubber washer over the hoses and data cable.
Slide the metal washer over, and lastly the mounting nut.
2. Tighten the screws with a Phillips screwdriver.
18 in
10 in
2. Mount Control Box
The preferred mounting distance between the spray hose and the control box
is 10 in. The preferred mounting distance from control box to the floor is 18 in.
1. Mount the control box under the sink using a Phillips head
screwdriver according to the preferred dimensions. Make sure to
leave some room to adjust.
2. Connect the outlet hose to the control box with
our innovative “quick connection”.
3. Connect the spray hose to the control box.
GETTING STARTED
Exposing this product to corrosive substances
or sharp objects may cause the hoses to rust
or become damaged. Install in a proper area
to avoid the risk of leaking.
To Next Page
Loading...
