Maintenance
• WARNING: Before any maintenance and / or cleaning the exterior of the heater, disconnect the heater form
the power supply and leave heater cooled off. The heater uses an electronically controlled LED system to
create the flame effect therefore no parts need to be replaced. Under no circumstances should the heater be
serviced by anyone other than a qualified electrician.
Safety Cut-out
• This heater is fitted with a safety cut-out which will operate if the heater overheats (e.g. Due to blocked air
vents). For safety reasons, the heater will NOT automatically reset.
• To reset the heater, disconnect the heater from the mains supply for at least 15 minutes. Reconnect the supply
to the mains and switch on the heater.
Care and Cleaning
• Always disconnect the heater from mains supply and allow cooling before any cleaning operation.
• Trim parts may be cleaned using a clean, damp cloth. Never use abrasive cleaners and chemical
agents as damage may occur to the finish.
Technical Specification
• Supply: 220-240V~ 50Hz
• Rated power: 2000W
• Lighting: LEDs
To Next Page
Loading...
