SpA BL 30 / 35
4
PICT n°4- -PICT n°6
INSTRUCTIONS FOR MOTORHOE ASSEMBLY
The machine is packed in a box of the following dimensions :
WIDTH: 80 cm. HEIGHT: 70 cm. LENGHT: 45 cm.
• Take the machine out of the carton box.
• Fit the two tillers to the main shaft using the delivered screws and nuts.
• Fit the rear spur in its place using the delivered bolt which is on the spur itself.
• Fit the handlebar on the support:
• The model with the vertical adjustment is fitted with two screws and nuts.
• The model with the full-side adjustment (rack, wheel system) is fitted with a single pin on the hand lever (PICT
18 Ref.”P”).
• Fit the front wheel to the frame using the screw and the cotter pin (PICT 7 Ref.”E”).
• Fit the two guard-extensions to the main tiller protections fitted on the body of the machine using the proper
screws and nuts. The protection guards should reach a width of 60 cm according to the CE.
-PICT n°7-
SECURITY TERMS
WARNING :
Please read very carefully this booklet before using your cultivator; Carefully
using and servicing this machine, you will certainly get satisfactory performances for a
long time.. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT
INSIDIOUS OR EVEN FATAL INJURY.
• The use of the machine is forbidden to persons younger than 16 years.
• The operator is responsible of any possible damage and he should always drive the machine carefully and safety.
• Before carrying the machine always empty the fuel tank.
• Before leaving the machine be sure that it is fully stopped.
• Never use the machine without heavy shoes and long transfers. Always inspect the area where you want to work taking off
stones, branches, cables and any other thing which can be dangerous.
• Before start working, make sure that a radius of minimum 5 mt. is completely free.
• Clean any possible leakage of fuel.
To Next Page
Loading...
