S.p.A.
FC 210 3VS
TECHNICAL DETAILS
FOR THE ENGINE FEATURES SEE THE ENGINE INSTRUCTION BOOKLET DELIVERED WITH THE MACHINE.
• Acoustic power level LwA = from LdB (A) 104 to 109 LdB (A)
• Acoustic pressure to the operator’s ear: LpA = from 91,5 dB (A) to 99,4 dB (A)
• Vibration to handles with weighting UNI EN 1033-1 value: from 14,9 m/sec2 to 24,61 m/sec2.
Testing conditions height 1.6 m handle midpoint.
• All the engines which can be fitted on this machine have the recoil starter and protection on the exhaust.
• Fuel for 4-stroke engine : Unleaded petrol
• Fuel for Diesel engine: Diesel oil
• Safety device on handles to stop machine
• Air filter in oil bath
• Consumption at 3600 r.p.m.: 0.8 Kg/hour
• ENGINE LUBRICATION: SAE 30 OIL
• Oil quantity in motor: 0.6 lt.
• Transmission : 2 Forward gears + Reverse gear
• TRANSMISSION LUBRICATION : SAE 80W/90 OIL
• Oil quantity in gearbox : 0.5 lt.
• Manually controlled wheel release and cutting bar
• Steering handles mounted on vibration-damping supports
• Rubber wheels 16/650.8
• Central mowing unit
• Manual-control clutch
• For machine identification (serial number, motor, weight, power), refer to the data plate as shown in the photo. See Pict. n.2.
PACKING AND TRANSPORT
◊
WIDTH: 116 cm.
◊
DEPTH: 42 cm.
◊
HEIGHT: 63 cm.
• Remove the power mower from its packing.
• Secure the handles with the screw (Pict. 9 Ref. “A”). The handle support is secured on anti-vibration devices (see Pict. 4 Ref.
“B”).
• Fit the cutter bar into the machine by the quick coupling (see Pict. 5)
• If the machine is to be transported, empty out the petrol tank and always apply the plastic protective strip to the E.S.M. cutting
bar blade. Read the E.S.M. sheet attached.
IMPORTANT: THE PACKED MACHINE IS SUPPLIED WITH THE MOTOR WITHOUT OIL OR PETROL.
22
To Next Page
