S.p.A. FT 7500
6
• If the engagement of the second forward speed is difficult, it is possible to adjust it by means of
the register of the lever Fig.2 Ref.”G”.
• If the belt of the reverse gear slips or tow when disengaged, adjust the registers of Fig2 Ref.”I” or
Fig 6 Ref.”D”.
• It is also possible to register the wheel unlocking device command wire (in case of engaging or
disengaging malfunction), through the register of Fig.2 Ref.”N”. (see Pics.6 Ref.”A”).
• The high grass mower has a double blade, in order to improve the breaking of cut material.
• When the mower is used in open fields or woody areas, it is possible to bring these modifications
to the machine:
1. remove the right side door (ref. A fig. 11);
2. mount the deflector cap (ref. B fig. 12);
3. mark the boundary of the working area as it 's shown in the draft below, before using the
machine. (Respect the measures indicated in the draft);
4. put warning signboards all around the working area. The signboards must report this inscription:
“Danger: throwing objects. Do not cross the enclosure.”
A B
ABCD = 20m X 20m (enclosed area)
A*B*C*D* = 15m X 15m (working area)
C D
Adjustment of the blade pulley belt tightener:
1. Disconnect the spark plug cable (ref. 18 page 2), before starting any operation.
2. Remove the front hood by unscrewing the four screws that fasten the cover (Pics 5 Ref. "B").
3. Engage the blade engagement lever (Pics 2 Ref. "B") so that the belt tightener, located beside
the driving shaft, is in engaged position.
4. Adjust the belt tension (Pics 7 Ref. "A") with the register (Pics 6 Ref. "C")
5. If this adjustment is not effective enough the operator can move the entire cutter assembly
6. Loose the two screws (Pics 7 Ref. “B”) blocking the hexagonal pipe , adjust the register screw
Fig.8 Ref.”A”, to shorten or lengthen de device following needs.
7. Tighten the two screws (Fig.7 Ref.”B”) and check that in brake engaged position the brake with
brake lining (Fig. 7 Ref.”C”), is correctly coupled with the pulley. If not, adjust the brake travel
through the adjustment rod Fig.7 Ref.”D”.
• If the machine has been subjected to heavy use, the discharge may tend to jam. If this happens,
the operator should: 1) raise the cutting height and 2) reduce the working section if the
grass is too high or thick.
• If the high grass mower is used near a wall or sidewalk, take care not to bang the blade as this
could lead to damage to the machine.
A* B*
D* C*
2,5 m
To Next Page
Loading...
