S.p.A. FT 7500
7
CAUTION:
It is advised not to keep the engine running when the
machine is not being used for its specific purpose
.
-Pics. n°4- - Pics. n°5- - Pics. n°6-
MAINTENANCE
! Before any maintenance or cleaning operation on the high grass mower disconnect the
spark plug cable.
! To change the oil or to perform other maintenance operations on the engine (spark plugs, air
filter, adjustments), refer to the engine instruction manual provided.
! N.B. To unscrew the oil drain cap of the engine, it is necessary to tilt it sideways.
! Make a regular check of the oil in the gearbox (Pics 9 Ref. "C")
! Every 200 hours change the oil completely by unscrewing the oil drain cap (Pics 9 Ref. "B"). Empty
out and screw back the cap. Fill the box from cap "C" (Pics9) until the oil level just reaches the
hole. Use only recommended oil.
! For any servicing, especially during the warranty period, seek the assistance of a dealer- authorized repair
shop.
! Make a regular check to verify that screws are tightened, specifically the screws fastening the
bar to their support. Ref.”A” Pics 10 and the threaded pins Rif.”B” Fig. 10, that fasten the
articulated blades to the blade support.
! When the blade does not cut adequately, it should be disassembled, sharpened and balanced.
An unbalanced blade may damage the machine with vibrations. . When it is very worn, replace it
with a new original one.
! BLADE SHARPENING OPERATIONS:
8. Disconnect the spark plug cable
9. Unscrew the pins that fasten the blades (Pics10 Ref. “B”)
10.Sharpen the cutting edge area with an emery grinding wheel.
11.Fit the blade paying ATTENTION to the cutting edge direction of rotation, that is, looking under the
machine, counterclockw ise.
12.Connect the spark plug cable again.
To Next Page
Loading...
