EasyManua.ls Logo

Benchmark 163CC - Setup Procedures and User Responsibilities; Engine Preparation for First Use; Operator Responsibilities

Benchmark 163CC
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
• NEVER attempt to make any adjustments or repairs while the engine (motor) is
running. Disconnect the spark plug wire and ground against the engine to prevent
unintended starting.
• Check grass catcher components and the discharge chute frequently, and replace
with manufacturer’s recommended parts when necessary.
• Mower blade is sharp. Wrap the blade or wear gloves and use extra caution when
servicing it.
• DO NOT change the engine governor setting or over speed the engine.
• Maintain or replace safety and instruction labels as necessary.
SETUP
PREPARING THE ENGINE
• IMPORTANT: This lawn mower is shipped WITHOUT OIL OR GASOLINE in the en-
gine.
• NOTE: Gasoline containing up to 10% ethanol (E10) is acceptable for use in this
machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product
warranty.
V. CUSTOMER RESPONSIBILITIES
• Read and observe the safety rules.
• Follow a regular schedule in maintaining, caring for and using your lawn mower.
• Wear proper personal protective equipment (PPE) while operating this machine,
including (at a minimum) sturdy footwear, eye protection and hearing protection. DO
NOT mow in shorts and/or open-toed footwear.
• ALWAYS let someone know you are outside mowing.
• NEVER allow children in the vicinity of any operating mower, even if the blades are
o. Children should be under the supervision of a responsible adult other than the
operator for the duration of the mowing operation.
• Follow the instructions under “Maintenance” section of the operator’s manual.
CAUTION: An Operator Presence Control is installed on this lawn mower in
order to minimize the risk of blade contact injury. DO NOT under any circum-
stances attempt to defeat the function of the operator control. The blade
turns when the engine is running.

Related product manuals