31
209CC PRESSURE WASHER, 3200 PSI
OWNER'S MANUAL
Overfilling with oil could cause the engine to not start, or hard starting.
• DO NOT overfill
• If over the FULL mark on dipstick, drain oil to reduce oil level to FULL mark on dipstick.
CHANGING OIL
If you are using your pressure washer under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often.
CAUTION Avoid prolonged or repeated skin contact with used motor oil.
• Used motor oil has been shown to cause skin cancer in certain laboratory animals.
• Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OIL TO COLLECTION CENTERS.
CHANGE OIL WHILE ENGINE IS STILL WARM FROM RUNNING, AS FOLLOWS:
1. Drain fuel tank by running pressure washer until fuel tank is empty.
2. Disconnect spark plug wire and keep it away from the spark plug.
3. Clean area around oil fill, remove oil fill cap/dipstick. Wipe dipstick clean.
4. Tip your pressure washer to drain oil from the oil fill into a suitable container making
sure you tip your unit away from the spark plug. When crankcase is empty, return the
pressure washer to upright position.
5. Slowly pour recommended oil (about 20 oz. [0.6 I]) into oil fill opening. Pause to
permit oil to settle. Fill to full mark (top hole) on dipstick.
6. Wipe dipstick clean each time oil level is checked. DO NOT overfill.
7. Replace and tighten dipstick.
8. Wipe up any remaining oil.
9. Reconnect spark plug wire to spark plug.
SERVICE AIR CLEANER
Your engine will not run properly and may be damaged if you run it with a dirty air
cleaner. Service more often if operating under dirty or dusty conditions. Or you can
purchase new by calling 1-833-818-4111.
TO SERVICE THE AIR CLEANER, FOLLOW THESE STEPS:
1. Loosen screw and tilt cover down.
2. Loose the disc knob and carefully remove cartridge assembly.
3. To clean cartridge, gently tap pleated paper side on a flat surface.
4. Reinstall clean or new cartridge assembly inside cover.
To Next Page
Loading...
