5044-026
20V MAX BRUSHLESS 2 SPEED POWER WASHER
6
before connecting the battery to the power tool or plugging it into the power
switch.
tools that have the switch on invites accidents.
Remove any adjustment key or wrench before turning the power tool on.
A wrench or a key left attached to a rotating part of the power tool may result
in personal injury.
Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected situations.
Dress properly. Do not wear loose clothing or jewellery. Keep your hair,
clothing and gloves away from moving parts. Loose clothing, jewellery or long
hair can be caught in moving parts.
Do not force the tool. Use the correct tool for the application. The correct power
tool will do the job better and safer when used at the rate for which it was designed.
Any power tool
that cannot be controlled using the switch is dangerous and must be repaired.
Remove the battery from the power tool or the plug from the power source
before making any adjustments, replacing or repairing parts, cleaning the
tool, leaving the tool idle or unattended, transporting or storing the tool. Such
preventive safety measures reduce the risk of starting the power tool accidentally.
Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
Maintain power tools. Check for misalignment or binding of moving parts,
tool’s operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
Use the power tool and accessories in accordance with these instructions,
taking into account the working conditions and the work to be performed.
in a hazardous situation.
GENERAL ELECTRIC GARDENING TOOL SAFETY WARNINGS – SERVICE
only identical replacement parts. This will ensure that the safety of the power
tool or charger is maintained.
5044-026f EnProdMaunal P_.indd 6 2020-12-17 2:00 PM