15
ATTACHING A GARDEN HOSE OR THE WATER INLET HOSE
1. Push the locking sleeve (1) of the garden hose/water inlet hose back and then
insert the connecting head into the hose quick connect adapter located on the
bottom rear of the power washer.
2. Release the locking sleeve on the garden hose/water inlet hose to lock in.
3. Pull on the garden hose/water inlet hose to ensure it is locked into the
power washer before use.
4. Select water source when using the water inlet hose supplied
with the power washer.
5. To remove garden hose/water inlet hose from the power washer, pull locking
sleeve on hose back and pull hose connecting head out of the hose quick
connecting adapter (Fig. 9).
OPERATION
STARTING/STOPPING THE POWER WASHER
1. Grip the power washer by the handle (3) in your preferred hand while balancing
the front of the tool with your other hand.
3. To stop the pressure washer, release the trigger switch (2) Fig. 10.
FIG. 9
FIG. 10
5044-026f EnProdMaunal P_.indd 15 2020-12-17 2:00 PM
IMPORTANT:
You must connect the water to the sprayer before installing the battery
to avoid water entering and damaging the battery.
IMPORTANT:
You must remove the battery before disconnecting the hose to avoid
water entering and damaging the battery.
To Next Page
Loading...
