11
5073-095
CORDLESS BRUSHLESS LAWN TRIMMER
10. Take care against injury from any device fitted for cutting the trimmer line
length. After extending new trimmer line always return the machine to its normal
operating position before switching on.
11. Never fit metal cutting elements. Only use 2.4mm / 0.095" or 2mm / 0.08"
rounded nylon line.
12. Never use replacement parts or accessories not provided or recommended by
the manufacturer.
13. Ensure that the battery pack has been removed before checking, cleaning or
working on the machine and when it is not in use.
14. Always ensure that ventilation openings are kept clear of debris.
15. During assembly take great care when fitting the guard as this has a very sharp
cutting edge on one side for cutting the nylon line.
16. Never hold the cutter head above foot height or point it towards people or
animals when in use.
17. If the trimmer starts to vibrate excessively switch o immediately and have it
checked by a qualified service engineer. CAUTION: The cutting head continues
to rotate for a few seconds after switching o.
18. Always remove any sticks and stones etc. before using the trimmer.
19. Do not cross roads or gravel paths while operating trimmer.
20. On steep slopes cut across the slope, never in an up and down direction. Never
run while using the trimmer.
21. Never use the trimmer while it is raining or in damp weather.
22. Do not overreach, keep proper footing and balance at all times.
23. Use only genuine spare parts. Only these spare parts are designed and suitable
for the product. The use of other spare parts not only voids the warranty, but
also endangers yourself and your environment.
24. Never use appliance for edging operation.
Special operation safety for the charger
1. Recharge only with the charger specified by the manufacturer. Do not use the
original charger on other li-ion batteries or on any other type of battery—fire or
explosion may occur.
2. Check the battery charger, cable and plug each time before using. Do not use
the battery charger when defects are detected. Do not open the battery charger
yourself. Have it repaired only by qualified personnel using original spare parts.
3. The charger is designed to use standard household 100~240 V, 50/60 Hz power
source. The charger’s plug must match the outlet. Never modify the plug in any
way. Unmodified plugs and matching outlets will reduce risk of electric shock.
To Next Page
Loading...
Need help?
General
