47
8. When you mow large areas, start by turning to the right so that the cut grass will
discharge away from shrubs, fences, driveways, etc. After one or two rounds,
mow in the opposite direction making left turns until finished.
9. The appearance of the lawn will improve if you alternate cutting in both
directions.
10. If the collector system tends to get blocked with grass; you should reduce the
forward speed as it may be too high for the condition of the grass. If the problem
persists, the probable causes are either badly sharpened blades or deformed
wings.
11. Be very careful when mowing near bushes or curbs as these could distort the
horizontal position of the cutting deck and damage its edge as well as the
blades.
TRANSPORT
To change work areas, the machine can only cover short distances.
▪ For longer distances, use a transport vehicle featuring loading ramps.
▪ Push the machine by hand and with the gear level lever in neutral “N”.
▪ Do not lift using cables.
▪ Secure the machine adequately during transport.
8. MAINTENANCE
SAFETY RECOMMENDATIONS
Always carefully follow the instructions in the
chapter: “Basic safety precautions” and in the paragraph “1.4” maintenance and
deposit.
Always replace the grass bag if it is torn, unstitched, or shows
damage to the plastic proles.
Due to the possible launching of grass and material collected up
by the blade.
Before carrying out any inspection, cleaning, and servicing
operations on the machine, and before unblocking the grass unloading pipe, stop the
engine, take out the ignition key and follow the instructions in the manual.
To Next Page
Loading...
Need help?
General
