84
AMBIENT TEMPERATURE
The SAE oil viscosity and service classification are in the API label on the oil
container. We recommend that you use API SERVICE Category SE or SF oil.
This engine is shipped from the factory without oil. Check the oil
level before starting the engine. If you start the engine without oil, the engine will be
damaged beyond repair and will not be covered under warranty.
• Check the engine oil level with the engine stopped and in a level position.
• Remove the oil filler cap/dipstick and wipe it clean.
• Insert and tighten the dipstick. Then remove the dipstick to check the oil level
• If the oil level is near or below the lower limit mark on the dipstick, fill with the
recommended oil to the upper limit mark. Do not overfill.
• Reinstall the oil filler cap/dipstick.
Engine oil capacities:
(0.132 US Gallon, 0.110 Imp Gallon)
Do not overfill. Overfilling with oil may cause:
• Smoking, Hard starting, Spark plug fouling, or Oil saturation of air filter.
• Used oil should be sent to a special recycle bin for disposal.
To Next Page
Loading...
