Benchmark H5000-H User Manual

H5000 Series MultiTherm Shakers
— 16 —
6．Changing the block
Screw
a) Open the transparent lid and use the
supplied hex wrench (3mm) to remove the
four screws that hold the block to the
heating board.
b) Close the lid and lift the block up and away
from the base unit.
c) Place the desired block softly on the
heating platform of the base unit and
carefully align the four screw holes.
d) Install and tighten the four screws. Do not
over tighten.

Benchmark H5000-H Specifications

General

Brand	Benchmark
Model	H5000-H
Category	Paint Sprayer
Language	English