14
OPERATION:
To Raise Lift;
"Position vehicle tires in the center of each runway.
"Set parking brake or use wheel chock to hold vehicle in position.
"Before raising vehicle, be sure all personnel are clear of the lift and surrounding area. Pay
careful attention to overhead clearances.
"Raise the lift to the desired height by pressing the push button on the power unit.
"After vehicle is raised to the desired height, lower the lift on the nearest safety lock. Do not
allow cables to be remain slack.
"Check to make sure all four safeties are engaged BEFORE ENTERING work area.
To Lower Lift;
"Raise the lift off the safety locks by pressing the push button on the power unit. Make sure
you raise the lift by at least two inches to allow adequate clearance for the locks to
clear.
"Press the push button air safety valve and HOLD.
"Push the LOWERING HANDLE on the power unit until the lift has descended completely.
When lowering the lift PAY CAREFUL ATTENTION that all personnel and objects are kept clear.
ALWAYS keep a visual line of site on the lift AT ALL TIMES. ALWAYS make sure that all FOUR
LOCKS are disengaged. If one of the locks inadvertently locks on descent the lift and/or vehicle
may disrupt causing personal injury or death.
Weekly Maintenance
"Lubricate all rollers with general purpose oil or WD-40.
"Check all cable connections, bolts and pins to insure proper mounting.
"Lubricate safety lock pivot points with general purpose oil or WD-40.
Monthly Maintenance
"Check safety locks to insure they are in good operating condition.
"Check all cables for excessive signs of wear
"Make a visual inspection of ALL MOVING PARTS and check for excessive signs of wear
"Replace ALL FAULTY PARTS before lift is put back into operation.
WARNING!
"NEVER EXCEED THE RATED CAPACITY of lift.
"DO NOT USE LIFT if any component is found to be defective or worn.
"NEVER OPERATE LIFT with any person or equipment below.
"ALWAYS STAND CLEAR of lift when lowering or raising.
"NEVER OPERATE LIFT with any person or equipment below.
"ALWAYS INSURE SAFETY LOCKS ARE ENGAGED before entering work area.
"NEVER LEAVE LIFT IN ELEVATED CONDITION unless all four safety locks are engaged.
To Next Page
Loading...